Product Details
Specification
Model ID |
NPM-TT2 |
PCB dimensions (mm) |
PC size |
Single-lane mode |
L 50 x W 50 ~ L 510 x W 590 |
Dual-lane mode |
L 50 x W 50 ~ L 510 x W 300 |
M size |
Single-lane mode |
L 50 x W 50 ~ L 510 x W 510 |
Dual-lane mode |
L 50 x W 50 ~ L 510 x W 260 |
PCB exchange time |
Single-lane mode |
4.0 s (With no component mounted on the reverse side of PCB) |
Dual-lane mode |
0 s* *No 0s when cycle time is 4.0 s or less |
Electric source |
3-phase AC 200, 220, 380, 400, 420, 480 V 2.5 kVA |
Pneumatic source |
Min.0.5 MPa, 200 L /min (A.N.R.) |
Dimensions *1 (mm) |
W 1 300*2 x D 2 798*3 x H 1 444*4 |
Mass |
2 690 kg (Only for main body:This differs depending on the option configuration.) |
Placement head |
Lightweight 8-nozzle head (Per head) |
3-nozzle head V2 *5 (Per head) |
Placement speed |
PC size |
18 000 cph (0.20 s/chip) |
7 200 cph (0.50 s/chip) 5 900 cph (0.61 s/QFP) |
M size |
17 460 cph (0.21s/chip) |
6 984 cph (0.52 s/chip) 5 723 cph (0.63 s/QFP) |
Placement accuracy (Cpk□1) |
± 40 µm/chip ± 30 µm/QFP □12mm to □32mm
± 50 µm/QFP □12mm Under
|
±40 μm/ chip ±30 μm/ QFP |
Component dimensions (mm) |
0402 chip*6 to L 32 x W 32 x T 12 |
0603 chip to L 150 x W 25 (diagonal152) x T 30 |
Component supply |
Taping |
Tape : 4 to 56 / 72 mm |
Tape : 4 to 56 / 72 / 88 / 104 mm |
Specifications for front/rear tray feeders : Max.52 Specifications for front/rear feeder carts : Max.120 (Tape:4, 8 mm) |
Stick |
Specifications for front/rear tray feeders : Max.12 (Single stick feeder) |
Specifications for front/rear feeder carts : Max.28 (Single stick feeder) |
Tray |
Max.40 (Front supply unit : Max. 20 + Rear supply unit : Max. 20) |
*1: Only for main body.
*2: 1 820 mm in width if extension conveyors (260 mm) are placed on both sides.
*3: Dimensions shown are specifications for front/rear tray feeders. Dimensions of specifications for front/rear feeder carts: 2 893 mm.
*4: Excluding the monitor, signal tower and ceiling fan cover.
*5: 3-nozzle head V2 cannot be installed on NPM-D3.
*6: The 0402 chip requires a specific nozzle/feeder.
*Placement tact time, inspection time and accuracy values may differ slightly depending on conditions.
*Please refer to the specification booklet for details.
http://www.sfgsmt.com/